Page 1 of 1

front sprocket replacement

Posted: Fri Sep 11, 2009 8:41 am
by millsy
having trouble breaking the nut loose to change my front sprocket on a 06 wr450. wondering if its reverse thread? any suggestions?

Re: front sprocket replacement

Posted: Sun Sep 13, 2009 5:39 am
by tydo58
I am having the same issue with my 08 KTM as I have a leaky seal in there. I cannot budge mine with a ratchet and socket alone and have heard they have factory red lock-tite. Some of the guys over at another site are saying that you need to hit it with an impact. From what I have been told these are not left hand thread as the sprocket turns counter clockwise during forward rotation. (makes sense)

I plan to go over to a friends today (HD mech.) and use his tools! I will try to keep you posted on how I make out.

Re: front sprocket replacement

Posted: Sun Sep 13, 2009 6:32 am
by WR_Dave
It is right hand threaded, I do use my impact gun to knock the nut off, but if you don't have that option, you can put the bike in a high gear and have someo one step down on the rear brake while you use a ratchet and socket with a snipe to pull up (from the rear side of the sprocket ) on the nut. Make sure the lock tabs are back far enough from the nut. WR Dave.

Re: front sprocket replacement

Posted: Mon Sep 14, 2009 4:25 am
by millsy
thanks for info guys :cheers: . I was a bit learry of putting a snipe on it until I knew it wasn't reverse thread. Back to the garage tonight to give it another shot.

Re: front sprocket replacement

Posted: Tue Sep 15, 2009 4:18 am
by millsy
1 foot snipe on a 1/2" drive rachet got it off no problem :thumbsup: .