2010 berg

New Bikes, Old Bikes, Bike Setup, Bike Mods, Questions, Riding Technique, Advice.
Post Reply
rpollard
2024 RMDRA Member
2024 RMDRA Member
Posts: 12
Joined: Sun Apr 09, 2017 7:29 pm

2010 berg

Post by rpollard »

Having trouble getting the tank off, I want to re-do some wiring that the previous owner did. 2010 husaberg 450fe. I have read take the rad out, or drop the rear sub frame. Any help? Thanks.

User avatar
malcolmzilla
2024 RMDRA Member
2024 RMDRA Member
Posts: 879
Joined: Fri Jun 26, 2009 11:14 am

Re: 2010 berg

Post by malcolmzilla »

Love riding my 570, but sure hate working on it, there ain't a finger width of room under there

Subframe can be dropped for wiring access, I don't recommend removing it fully.

IIRC rough steps:

remove seat
take a good picture of how all the underseat wiring components are located
disconnect battery
remove rad shrouds
remove exhaust can
remove subframe brace
remove two top subframe frame bolts, loosen third lower one
subframe should drop enough to open up the underseat wiring - watch out for the fuel pump wiring not to get yarded
i chose to fish my auxiliary power wire under the seat to the airbox and under the rad shrouds to the front, keep it away from heat and abrasion

tank i cant recall where the bolts are from memory, but if you pull the air filter and push the boot through the tank, you can move it a bit - i cant recall if the header has to come off too, but then you should be able to fish a wire through there
15 Yamaha YZ250FX, 270cc, cams
15 XC250
11 Berg 570, dualsport and supermoto
17 PW50
78ish CT70
Just another Dirt Donkey...

rpollard
2024 RMDRA Member
2024 RMDRA Member
Posts: 12
Joined: Sun Apr 09, 2017 7:29 pm

Re: 2010 berg

Post by rpollard »

Thanks I'll give it a go.

Post Reply