Rocky Mountain Dirt Riders

Looking to put some linkage protection on my 2015 350 XC-F...any recommendations? I have a Scorpion skid plate on there now, so I was hoping I could just add something to what I already have. Thoughts?

In the same boat curerntly..

I'm trying to source some 1/4" UHMW sheet (same plastic they make chain slide and guides from)... cut a chunk 5"x10" (ish) bolt it on the back of the skid plate..

I would think it should provide enough impact protection.. not forever but easy to replace.

Obie, i have them on two bikes, great product. Light, glides over rocks/logs well, keeps mud out of linkage and is cheap $$.
Available at BFD.

x2 on the Obie, cheap and effective, running em on my YZ's.

obie hey.. might have to check them out and save the hassle of making one.

I run one of these and it is bullet proof. A seamless transition between the skid and linkage. I have wrecked fastways before so I know I am a good test pilot. I am not afraid to run this in Moab or in endurocross.

http://www.sxslideplate.com/
However, if you have a skid already, then the Obie is awesome too

I'll give the Obie a try...thanks for th insight!

CPitty wrote:I'll give the Obie a try...thanks for th insight!

Picked one up from BFD yesterday...$80 and in stock. Thanks for the help!

I picked up a bullet proof designs link guard it covers the lower section of the linkage but it is not complate coverage like a Fastway. once I test it on a few logs and rocks we will see how it holds up.

Cycle Works has Obies on the way!

Put me down for one!