TIG welding

[WRocks]

I have a high end TIG welder and can repair basically anything made out of metal especially aluminum.

- Sub-frames
- Skid plates
- Hand guards
- Gearshift & Brake levers (so they can be used for a spare)

I can also do case parts, but will need to have a closer look to determine metallurgy and difficulty before committing. Radiators are probably a no go, due to thin material and difficulty at getting a weld at the leak site. However, I’d like to try some, but only if it’s a write off as I can’t guarantee I can do it successfully.

Rate is negotiable depending on what it is and the difficulty, but I guarantee it’s cheaper than taking your stuff to AreoTech who have a $75 minimum.

Break out some of that expensive stuff you just couldn’t throw away, because of what you paid for it…

Get in touch with me by PM if interested.

[MotorEd]

TIG Welder/Pipe Master/Trail Maintenance God,

Unta hav za skeed platza daz in bad needz a repar from unta masta tig veldah yah?

Holy schezenholen isa loaded.

U gotz velden, I gots velden neeedz.

[steve-o]

TIG Welder/Pipe Master/Trail Maintenance God,

Unta hav za skeed platza daz in bad needz a repar from unta masta tig veldah yah?

Holy schezenholen isa loaded.

U gotz velden, I gots velden neeedz.

I told you - NO RUM ON MONDAY!

[WRocks]

Sounds Good MotorEd, I can add it to you tab for the pipe repair...lol