Anybody Do Sheet Metal?
Anybody Do Sheet Metal?
Im looking to do my workbench top in stainless or galvanized - any sheet metal folks on here?
Re: Anybody Do Sheet Metal?
Try Sureway Metal Systems or Quest Fabrication, both are located close to Blackfoot
RMDRA lifetime member
2013 350 XCF
2015 450 SXF with Timbersled MHLT
2013 350 XCF
2015 450 SXF with Timbersled MHLT
Re: Anybody Do Sheet Metal?
I would recommend aluminum. Softer than your parts, easier to fasten to your table, warms quicker on garage, less risk of rust, many advantages.
'18 300 XC
'02 XR650R
'02 XR650R
Re: Anybody Do Sheet Metal?
Go see Craig at Calgary Aluminum, tell him Giles sent you.