Rocky Mountain Dirt Riders

I noticed that I have a fatigue crack in the lower mounting tab on my 250 XC-W radiator. Anyone have a suggestion as to where I can get a modest welding job done on it? The radiator is otherwise in good shape.

OK. I'll let it go for $75.

KTM part number 54830206000 SX cylinder head, fits all KTM 250's from 2007-2016. Raises compression on XC and especially XC-W bikes, easy bolt on installation that increases torque and doesn't require any jetting changes. Best hop up you can do for these bikes. New msrp is $185, I'm looking for $100...

I think I'm ok. Or maybe just very lucky. Not having any expectation of success I went out and gave it one more effort and using the smallest drill bit I managed to drill a hole right through the bottom of the bolt stub. My smallest sized extractor then got a really good bite on the bolt fragment an...

My 2013 KTM 250 XC-W kickstand bolt failed leaving a sheared off bolt shaft that's flush with the top of the mounting lug on the frame. I tried screw/bolt extractors starting off with a smaller size and after no success I worked my way up to the largest size I could use. The bolt refused to come out...

Items are sold!

Sold.

I only check my text messages when I'm driving my car.

Oops. Forgot phone nbr: 403-560-7071

Adult size small Fox V1, quite good shape as junior got more interested in computers than dirt bikes shortly after getting this helmet. $75. And if you've got a Kawasaki I've got you covered with a pair of green 100% goggles. Good condition on these with a couple of brush scuffs on the lens. Yours f...

Size 9/euro 43. Slightly wider all terrain version. The older 4 buckle design...they cheaped out on the new iteration with a lousy 3 buckles! $75. 403-560-7071.

Page 47.

https://www.ktm.com/globalassets/produc ... pi__v1.pdf

I've got a chain breaker, though I'm not sure how close I am to you. As an alternative, if you have an electric drill and a grinding wheel you can always try grinding down the stakes and then prying the link's side plate off with a screwdriver. I've done that in the past and it works reasonably well...

How about for the KX200? Link to pdf download (really is free): http://is.gd/_KDX200_Service_Repair_Manual

Sold!